Yard Sale

How to Order

Please use the form on the “How to Order” page to send me a message with a list of items you are interested in. I will send a return email with the price of the items, shipping charges, and the total cost. Once you have confirmed, I will send a Paypal invoice for the total charge.

If you have questions about items or ordering, please contact me.

Tasco Field Glasses

Tasco 7×35

Price: $35.00

Tasco Zip Focus 7 x 35 binoculars. Barely used and in good condition. Wide angle-525 feet at 1,000 yards. Fully coated optics. Light weight. Soft carrying case. One eye piece lense cover is missing.

Thermolyne FB1410M Furnace

1410 furnace

Price: $450.00

Used FB1410M muffle heat treating furnace. Dimensions interior 6″ x 5″ x 4.5″. Dimensions exterior 15.8″ x 10″ x 14.5″ 230 VAC 60 hertz single phase. Operating temperature is 212 F to 1,800 F however I would limit the temp to 1,600 degrees F. The furnace would be fine for annealing brass cases or heat treating steels that have a lower hardening temp. The heating elements come as a flat ceramic sheet with the elements embedded in the sheet. The sheet is folded at the indicated places. The old elements come out the rear of the furnace, the new one is slipped in, and connected to the wiring. Much easier than fooling around with a loose coil of high temp wire. Operators manual included.

I would still be using this furnace but needed one that can operate at higher temps and no longer need this one. Photo is of a new unit.

Bore Gages

The next items are bore gages and setting fixtures for them. There are four gages covering diameters from .495″ up to 6.0″. The gages are in like new condition and complete with all of the parts that came with them.

I got these when doing parts on the vertical mill and needed a way to measure holes very accurately and without human error. There is simply nothing that will compare to the Sunnen bore gages. These are available separately or a special price is available for the set. I now have the parts made by a CNC shop and no longer need the gages. The photos were taken outside and clouds are reflected in the gage bezel.

Dial Bore Gage

GR-4101

Price: $495.00

Sunnen Products Co. Dial bore gage. Measures from .495″ up to .750″ and up to 5″ deep. I’ve used this when making large caliber bullet swages but more when making parts on the vertical mill. A new gage from Sunnen is $1,165.00. There are similar gages made by other companies but none compare to the Sunnen products. Plus should it be needed replacement or repair parts and calibration are available from Sunnen. Comes with a case, setting micrometer, and tools. It is a serious tool for serious machinists & die makers.

VTech Cordless Phones

VTech Phones

Price: $55.00

Vtech cordless phone system. IS8128-5 Used for a couple of months and then discontinued the third phone line this was used with. DECT 6.0 with Bluetooth. Base station with handset plus four handsets and chargers. Answering machine in phone base. Smart call blocker. Connect to cell phone. Caller ID. Remote voice control. Phonebook stores 1,000 entries. ECO mode reduces power consumption. Lots of featues that are beyond my limited understanding but most can be ignored if not wanted.

Reloading Dies 43 Mauser

43 Mauser dies

Price: $30.00

43 Mauser reloading die set. Two die set. Lee Precision. Includes an RCBS style shellholder. Load your own ammo for the M-71 and M-71-48 Mausers and some Remington Rolling Block rifles. Good condition, never used.